Pre-Cut Shims
Portable Jack Bolts
Alignment Bolts
Sanitary
Pump Seals
Alfa-Laval Seals
APV Seals
Fristam® Seals
Tri-Clover® Seals
Waukesha® Seals
ANSI Pump Seals
ZA Sgl Cartridge Seal
ZN Sgl Cartridge Seal
ZND Dbl Cartridge Seal
Seal Application Sheet
Tri-Clover
®Parts
Waukesha®Parts
Waukesha®Pump Repair
Chemical Recovery
pH Control System
 |
|
|||||||||||||||||||||||||||||||||||||||||||||||||||
|
Stop mechanical seal damage from pumps running dry. Stop damage to conveyors, pulpers, finishers or any other equipment that will be damaged by operating empty or broken. | |||||||||||||||||||||||||||||||||||||||||||||||||||
|
|
Save money by not destroying your mechanical seals. Save time by eliminating unnecessary repair to damaged equipment. Increase productivity by reducing equipment downtime. |
|||||||||||||||||||||||||||||||||||||||||||||||||||
Applications: Pumps with mechanical seals, magnetic drive pumps, progressive cavity pumps, conveyors, fans, automated packaging equipment, and finishers. |
||||||||||||||||||||||||||||||||||||||||||||||||||||
|
Stop motor damage and false trips caused by unreliable motor starter heaters. Stop equipment damage by operating equipment empty, dry, broken or from an overload condition. | |||||||||||||||||||||||||||||||||||||||||||||||||||
 |
|
|||||||||||||||||||||||||||||||||||||||||||||||||||
Applications: Motor overload, pumps with mechanical seals, magnetic drive pumps, progressive cavity pumps, conveyors, fans, automated packaging equipment, and finishers. The Equiprotector is a solid state electronic device for protecting equipment from overload and/ or underload conditions. Overload is typically an indication that something is causing undue load on the motor and if left undetected will cause equipment damage. Underload, low amperage, is typically an indication that something is wrong, or that the equipment is running dry, empty, broken, or without product and if left undetected can be damaged. All Equiprotector
models are user friendly, easy to install, setup, and operate. Equipment
modifications are usually not necessary. AC current sensing is accomplished
by simply routing one motor lead through the window of a sense transformer.
Connections to existing electrical terminals are not necessary,
nor is it necessary to modify or change existing wire routing. Since
all functions are electrical, a physical pipe or plumbing change
is not needed either. The relay connections are then used to set
off an alarm, or shut off the equipment, or both. |
||||||||||||||||||||||||||||||||||||||||||||||||||||
| EQUIPROTECTOR | ||||||||||||||||||||||||||||||||||||||||||||||||||||
|
||||||||||||||||||||||||||||||||||||||||||||||||||||
| Two Equiprotector current sensor models are available:
(**) 230 VAC operation optional (***) Using ether two current/HP Cards or two Temperature Cards |
||||||||||||||||||||||||||||||||||||||||||||||||||||
|
||||||||||||||||||||||||||||||||||||||||||||||||||||
Files
Fristam®, Tri-Clover®, and Waukesha® are trademarks of their respective companies.
ZMT, Inc. is not a representative, nor affiliated with Alfa-Laval, APV, Fristam®, Tri-Clover®, or Waukesha®.
Copyright
© 2000-2002 ZM Technologies.
